FP Sigma
Select the Following Items
Frequently Asked Questions
- GT30: Can I switch screens by using both the function switch and programmable controller?
- Recent notebook computers don’t have serial ports, but have USB ports only. How do I connect PLCs, such as FP0, FP1, and FP10SH to edit the programs?
- When connecting FP0 to GT30 and conducting a rewriting operation in RUN mode using the “through” function, “NOT SUPPORTED” error occurs. This does not occur when using FP2. Why?
- The internal relay turns itself on when the power is turned off and on.
- Is it possible to use PLC Link while carrying out general-purpose communications (FPG-COM4)?
- Are there any program examples for CRC for communications with a temperature controller?
- I need to move a tool in an S-shape by controlling two axes using FPG-C32T and FP0-E32T. How do I program them? I don’t know how to program well.
- Recent notebook computers don’t have serial ports, but have USB ports only. How do I connect PLCs, such as FP0, FP1, and FP10SH to edit the programs?
- How are I/O points allocated to expansion units added on the left side? If they are also added on the right side, will the I/O numbers change?
- How do I adjust the response time of communications between FPΣ and a computer via RS485?
- If CH0 and CH2 of FPΣ are programmed for positioning so that only one of the channels outputs pulses at a time, is it possible to achieve a 100kHz output frequency?
- How do I connect GT30 to FPΣ?
- How do I establish both a PLC link and general-purpose communications using FPΣ?