FP-X
Select the Following Items
Frequently Asked Questions
- I’m planning to use FP-X. At present, there are only five COM port numbers that can be assigned by FPWIN G (1 to 5), and all of them are used by the system. How can I increase the number of COM port assignments? In addition, if the USB port of FP-X is connected, can it be recognized?
- GT30: Can I switch screens by using both the function switch and programmable controller?
- When connecting FP0 to GT30 and conducting a rewriting operation in RUN mode using the “through” function, “NOT SUPPORTED” error occurs. This does not occur when using FP2. Why?
5results of "FP-X"
- If GT11 is connected to the 2ch port of a FP-XCOM6 communication cassette (RS485x2ch type), operation of a switch or a lamp may become slow and it may not operate. A setup of COM2 (2ch port) is a computer link. In addition, in COM1 (1ch port), it operates normally satisfactory. Why is it?
- I’m planning to use FP-X. At present, there are only five COM port numbers that can be assigned by FPWIN G (1 to 5), and all of them are used by the system. How can I increase the number of COM port assignments? In addition, if the USB port of FP-X is connected, can it be recognized?
- Recent notebook computers don’t have serial ports, but have USB ports only. How do I connect PLCs, such as FP0, FP1, and FP10SH to edit the programs?
- GT30: Can I switch screens by using both the function switch and programmable controller?
- When connecting FP0 to GT30 and conducting a rewriting operation in RUN mode using the “through” function, “NOT SUPPORTED” error occurs. This does not occur when using FP2. Why?