FP0
Select the Following Items
Frequently Asked Questions
- GT30: Can I switch screens by using both the function switch and programmable controller?
- Recent notebook computers don’t have serial ports, but have USB ports only. How do I connect PLCs, such as FP0, FP1, and FP10SH to edit the programs?
- When connecting FP0 to GT30 and conducting a rewriting operation in RUN mode using the “through” function, “NOT SUPPORTED” error occurs. This does not occur when using FP2. Why?
- I’m using FP0 SL1. When executing the total check on-line, "Duplicated output error" message was indicated. How do I solve this?
- Are common pins with the same names in MIL type input connectors and output connectors connected internally?
- IF168 (SPD1) instructions it possible to return to home position using only the home position sensor without using the near home sensor?
- F168 (SPD1) instructionWill deceleration start when the near home sensor turns on during acceleration when home position return is taking place?
- F168 (SPD1) instructionWill the home position return operation complete even immediately after the near home sensor is input when the home position return mode is set to H24, H26 or H27 (home position input valid after near home input)?
- F168 (SPD1) instructionDoes FP0 start pulse output when home returning is execated under the home position sensor has been turned on?
- F168 (SPD1) instructionCan outputs Y2 and Y3 be used for another purpose when "Do not use directional output." is set ?
- F168 (SPD1) instructionHow long does it take to output the pulse after the directional signal turns on?
- The FP0 COM port has only three pins. How do I connect it to another piece of equipment?
- How do I get the Chinese manuals for FP0 and FPWIN GR?