FP Sigma
Select the Following Items
Frequently Asked Questions
- Recent notebook computers don’t have serial ports, but have USB ports only. How do I connect PLCs, such as FP0, FP1, and FP10SH to edit the programs?
- When connecting FP0 to GT30 and conducting a rewriting operation in RUN mode using the “through” function, “NOT SUPPORTED” error occurs. This does not occur when using FP2. Why?
- GT30: Can I switch screens by using both the function switch and programmable controller?
- I need to use a flat cable for connecting the FPΣ 64-point I/O units. Which connectors should I order?
- What precautions must be taken for using the data backup battery for FPΣ?
- GT30: Can I switch screens by using both the function switch and programmable controller?
- I’m using a combination of FPΣ (FPG-C32T2) and the communication cassette (FPG-COM1) for the FS232C transfer. However, the hardware flow control of RS-CS doesn’t work well. Even when I directly monitor the terminals, no changes were found. I must get the FPΣ flow control working so that I can send large volumes of data. How do I stop the transmission request (RS: LOW)?
- Are 2-ch serial communications possible for FP0 without using the TOOL port?
- Which I/O connector should I use for FPΣ? Which wire should be used for the connector?
- H10 should be written in DT90052 of CH0 of FPΣ for the near-home position deceleration start. For CH2, what should be written?
- I will use the positioning control function of FPΣ. What is the deviation counter clear output of Y2?
- Regarding FPΣ general-purpose communications for control, when powering on the target equipment and then the FPΣ unit, communications are normal. However, when powering on the FPΣ unit and then the target equipment, they won’t communicate normally. Is this possible?
- Is S-curve positioning control available with FPΣ?
