FP2
Select the Following Items
Frequently Asked Questions
- Recent notebook computers don’t have serial ports, but have USB ports only. How do I connect PLCs, such as FP0, FP1, and FP10SH to edit the programs?
- When connecting FP0 to GT30 and conducting a rewriting operation in RUN mode using the “through” function, “NOT SUPPORTED” error occurs. This does not occur when using FP2. Why?
- GT30: Can I switch screens by using both the function switch and programmable controller?
- Since the program space becomes insufficient, I need to change the CPU unit. If I change FP2 to FP2SH, can the other units be used as they are?
- I’m using four interruption input points of the FP2 high-speed counter unit. How does the unit operate when multiple interruption instructions are executed simultaneously?
- I need to have the FP2 positioning unit multifunction type perform home position return, but there are not near-home position switches. How do I set it if there are only limit switches on both ends and a home position switch?
- When the I/O points of FP2-XY64D2 are allocated, will the output points be Y30 to Y4F if the input points are X10 to X2F? Can Y numbers be allocated first instead?
- If a communication error occurs during W-link communications, what will happen to the link relay or link data? If a communication error occurs during F-link, what will happen to the output?
- Can the FP2 multi-wire link unit be used as either a master or slave station? (I need functions equivalent to those of the FP3 slave unit.)
- GT30 made a general-purpose serial communication setup is connected to the COM port of FP2. However, they don’t communicate. There are no problems in either the cable connection or electric continuity.
- I’m using ch1 to ch6 of the FP2 A/D unit for current input. When increasing the current input to channels other than, for example, ch1, the reading of ch1 also increases accordingly. How do I prevent this?
- What’s the part number for ordering the CR2450 battery for backing up PLCs?
- GT30: Can I switch screens by using both the function switch and programmable controller?
